Subaru VDC System Filter Clogged: How to solve with SSM 3 or SSM 4. Retailers will perform an ABS sequence control (activation), then flush and replace the brake fluid in all potentially affected vehicles. Not all vehicles in the VIN ranges listed below are affected by this campaign. Coverage for all affected vehicles must be. Subaru Select Monitor III v1.45.59.9 Multilanguage Win 756 MB The program for the dealer level diagnostics of all car brand Subaru, with diagnostic connector OBD-II (which is virtually all cars Suba.
Here is the guide to troubleshoot Subaru IMPREZA 2004 with SSM III or FreeSSM software.
Model: Subaru IMPREZA 2004
Tools to use:
Subaru FreeSSMV1.2.5 diagnostic cable
VXDIAG Subaru SSM III multi diagnostic tool
1 CHECK ENGINE START FAILURE.
1)- Ask the customer when and how the trouble occurred using the check list for interview.
2)- Start the engine.
Does the engine start?
YES–> Go to step
NO–> Diagnostics for engine start failure:
i- Check for fuel amount.
ii- Inspection of starter motor circuit.
iii- Inspection of ECM power supply and ground line.
iv- Inspection of ignition control system.
v- Inspection of fuel pump circuit.
vi- Inspection of fuel injector circuit.
2 CHECK ILLUMINATION OF MALFUNCTION INDICATOR LIGHT.
Does malfunction indicator light illuminate?
YES–> Go to step 3
NO–> General diagnostics table
3 CHECK INDICATION OF DTC ON DISPLAY.
1)- Turn the ignition switch to OFF.
2)- Connect the Subaru Select Monitor or the OBD-II general scan tool to data link connector.
3)- Turn the ignition switch to ON and the Subaru Select Monitor III or OBD-II
scan tool switch to ON.
4)- Read the DTC on the Subaru SSM III or OBD-II scan tool.
Does the Subaru Select Monitor or FreeSSM software indicate DTC?
YES–> Record the DTC. Repair the trouble cause. Go to step 4.
NO–> Repair the related parts.
NOTE:
If DTC is not shown on display although the malfunction indicator light illuminates, perform diagnostics of malfunction indicator light circuit or combination meter:
i- Activation of malfunction indicator light.
ii- Malfunction indicator light does not come on.
iii- Malfunction indicator light does not go off.
iv- Malfunction indicator light does not blink at a cycle of 3 Hz.
v- Malfunction indicator light remains blinking at a cycle of 3 Hz.
4 PERFORM THE DIAGNOSIS.
1)- Perform the clear memory mode.
2)- Perform the inspection mode.
Does the Subaru Select Monitor or FreeSSM OBD-II general scan tool indicate DTC?
YES–> Diagnostics Procedure with Diagnostic Trouble Code (DTC):
DTC P0030 HO2S HEATER CONTROL CIRCUIT (BANK 1 SENSOR 1)
- DTC DETECTING CONDITION:
- Two consecutive driving cycles with fault
NO–> Complete the diagnosis.
Attachment:
Subaru IMPREZA diagnostic trouble codes (DTC) and expalnation: